Installing a body lift in your Ford Ranger may be achieved your self with easy tools. Adding a body lift to your truck will help you purchase larger tires. body lift kit solely the lift the body off the frame of the vehicle, and retain the manufacturing unit suspension. The trip and handling is not sacrificed. Body lift are a cost-effective method to enhance the off-road performance of your Ford Ranger.

Preparing the Ford Ranger for Body Lift Kit Installation

1. Park the vehicle on a flat surface and apply the parking brake.
2. Open the hood and disconnect the detrimental battery cable utilizing a socket. The negative cable is the black cable that connects to the battery.
3. Disconnect the bolts on the fan shroud and the fan from the entrance of the grille. The bolts might be removed utilizing a ratchet and a socket. Permit the fan and the shroud to relaxation contained in the automobile’s engine compartment.

Ford Ranger Cab Portion of the Body Lift Installation Instructions

1. Remove the front bumper of your Ford Ranger. There are three bolts on each end of the bumper. Take away these bolts with a ratchet and socket. Place the front bumper aside.
2. Remove the kick panels from contained in the automobile’s interior with a screwdriver. Grasp the carpet and pull again to expose the manufacturing unit body bolt contained in the cab. There are two body bolts on each side of the Ford Ranger. The bolts are located within the entrance kick nicely and behind the seat. Loosen and remove these bolts using a ratchet and socket.
3. Place a hydraulic jack on the driver’s side of the vehicle. A block of wooden ought to be used between the jack and the vehicle’s undercarriage to stop damage to the kick panels. Place the jack ready so it lifts the body of the vehicle. Only carry the automobile enough to slide the body lift pucks onto the manufacturing unit bushings.
4. Slide the body lift pucks into position on prime of the factory bushings. Do not remove the factory bushings. Lower the vehicle body onto the newly put in carry pucks.
5. Install the new bolts into place and tighten them utilizing a ratchet and socket. Confirm that all six bolts are tight. Re-set up the bumper, fan, and shroud utilizing a socket and ratchet.

Ford Ranger Bed Portion of the Body Lift Installation Instructions

1. Find all eight of the factory bushings along the frame rail connecting the Ranger mattress to the frame. There are four bushings on each side of the vehicle.
2. Loosen and take away the bolts holding the mattress onto the frame.
3. Slowly jack up the car in the identical fashion. A block of wooden ought to be used to forestall damage to the vehicle. Raise solely enough to slide the pucks into position. Decrease the mattress onto the pucks by decreasing the hydraulic jack.
4. Set up the brand new bolts that came with the body lift kit. Tighten them with a socket and ratchet.
5. Re-install the negative battery cable.